Panasonic SC-ALL2 User Manual

- 37 -
∫ To switch to network speaker mode
Turn SC-ALL70T/SC-ALL30T and SC-ALL2 off and then turn SC-ALL2 on
again.
≥ The network indicator will light up or blink.
≥ The audio source will change to the network.
∫ To switch to rear surround mode
Touch and hold [AUX] and [6] on each SC-ALL2 for at least 4 seconds.
≥ The network indicator will go off.

≥ The pairing mode is cancelled after about 2 minutes elapses. You can also
touch [Í/I] to cancel it.
≥ When this unit is in rear surround mode, turning the paired SC-ALL70T/
SC-ALL30T on/off will automatically turn this unit on/off.
≥ The below functions may not be available when this unit is paired as rear
surround speaker.
– Streaming music by network
– Alarm/Sleep timer
– Changing to other selector (AUX, Bluetooth
®
, Network)
– Adjusting volume with this unit
≥ You cannot adjust the delay time with this unit.

Panasonic SC-ALL2 Specifications

General

Speaker type	1-way
Tweeter diameter	80 mm
Number of speakers	1
Audio output channels	1.0 channels
Impedance	- Ω
Frequency range	- Hz
RMS rated power	40 W
Headphone out	Yes
Connectivity technology	Wired & Wireless
Product type	Mono portable speaker
Product color	Black
Recommended usage	Universal
Audio formats supported	AAC, FLAC, MP3, WAV
Power source type	AC
AC adapter frequency	50/60 Hz
AC adapter input voltage	100 - 240 V
Power consumption (standby)	1 W
Power consumption (typical)	22 W
Quantity per pack	1 pc(s)

Weight and Dimensions

Depth	120 mm
Width	110 mm
Height	174 mm
Weight	4200 g