Paradox MG-RCV3

Magellan Wireless Expansion Module 19
6.3.2 On-Board Module Tamper Supervision (Digiplex Series only)
DIGIPLEX/DIGIPLEXNE: SECTION [001]: OPTION [5]
6.4 Ignore Wireless Transmitter Tamper Signal
SPECTRA: SECTION [610]: OPTION [8]
D
IGIPLEX SERIES: SECTION [001]: OPTION [8]
With this feature disabled, the MG-RCV3 will disregard any tamper signals
coming from any of its assigned wireless transmitters. As a result, the MG-
RCV3 will not send a tamper signal to the control panel therefore not
generating a trouble, an alarm and/or a report code to be sent to the monitoring
station.
How to enable/disable the module tamper supervision:
In step 5 in section 3.2 on page 8:
1. Enter section [001].
2. Enable or disable option [5].
Option [5] OFF = On-Board Module Tamper Supervision
disabled (default)
Option [5] ON = On-Board Module Tamper Supervision
enabled
How to program the Ignore Wireless Transmitter Tamper Signal feature:
Spectra
In step 3 in section 3.1 on page 8:
1. Enter section [610].
2. Enable or disable option [8].
Option [8] OFF = MG-RCV3 will ignore tamper signal (default)
Option [8] ON = MG-RCV3 will recognize & report tamper signal
Digiplex Series
In step 5 in section 3.2 on page 8:
1. Enter section [001].
2. Enable or disable option [8].
Option [8] OFF = MG-RCV3 will ignore tamper signal (default)
Option [8] ON = MG-RCV3 will recognize & report tamper signal
MGRCV3SD_EI01.fm Page 19 Thursday, May 5, 2005 2:22 PM