Paradox MG-RCV3 User Manual

28 Reference & Installation Manual
The User Code assigned to the remote control (refer to section 8.2 on
page 25) must have the same options enabled as the remote control.
For example, if you enable the Force Arming button option, you must
enable the appropriate Force Arming user option in the control panel.
Also, if you enable any Panic button options, you must enable the
Panic options in the control panel (refer to the appropriate Reference &
Installation Manual).
In Spectra systems, to verify the remote control button programming
using LED keypads, enter the desired section, press the [
ENTER] key to
enter display mode and then press [ENTER] once for every value. The
LED hexadecimal indicators (refer to Table 8.5 on page 32) will
illuminate one at a time as you press the [
ENTER] key.
Table 8.3: Remote Control Button Programming
RC#
Spectra
Section
Digiplex
Series
Section
RC Buttons
(refer to Table 8.4 on page 30)
Default: ( 1 5 0 0 0 0 0 0 )
1 [711] [401]
_____/_____/_____/_____/_____/_____/_____/_____
2 [712] [402]
_____/_____/_____/_____/_____/_____/_____/_____
3 [713] [403]
_____/_____/_____/_____/_____/_____/_____/_____
4 [714] [404]
_____/_____/_____/_____/_____/_____/_____/_____
5 [715] [405]
_____/_____/_____/_____/_____/_____/_____/_____
6 [716] [406]
_____/_____/_____/_____/_____/_____/_____/_____
7 [717] [407]
_____/_____/_____/_____/_____/_____/_____/_____
+
+
+
+
+
++
+
+
++
+
+
++
+
+
++
+
+
++
+
+
++
+
= These button combinations are not available with the
MG-REM1 remote control and cannot be programmed.
MGRCV3SD_EI01.fm Page 28 Thursday, May 5, 2005 2:22 PM

Paradox MG-RCV3 Specifications

General

Brand	Paradox
Model	MG-RCV3
Category	Control Unit
Language	English