To Next PageTo Next PageWhat to do if my Parker Controller displays 'Inverter Overload'?
If your Parker Controller is showing an inverter overload, it could be due to a load that is too heavy. Try to reduce the load, check the drive ratio, or increase the inverter’s capacity.
General| Overload Capacity | 150% for 60 seconds |
|---|---|
| Analog Inputs | 2 |
| Analog Outputs | 1 |
| Communication Options | Modbus RTU |
| Protection Rating | IP20 |
| Input Voltage | 200-240VAC, 380-480VAC, 500-575VAC, 600VAC, 690VAC |
| Digital Outputs | 2 |
| Protection | Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit |
| Operating Temperature | -10°C to +50°C |
| Humidity | 5% to 95% (non-condensing) |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Braking | Built-in dynamic braking |
Important precautions to take before and during equipment installation.
Explains how to set and modify inverter parameters using the keypad.
Guidelines for vertical installation and required clearance dimensions.
Instructions for connecting power supply, motor, and grounding terminals.
Detailed description of each control terminal and its function.
Techniques for reducing electromagnetic interference (EMI) and noise.
Explains how to use the keypad for parameter setting, monitoring, and control.
Covers fundamental parameters like password, rated current, power, and control mode.
Parameters related to start/stop commands, direction setting, and frequency sources.
Configuration of digital and analog I/O terminals for various functions.
Parameters for configuring analog input channels and output signals.
Parameters for overload protection, fault detection, and system protection.
Crucial parameters for motor identification, tuning, and performance optimization.
Settings for Modbus communication, including address, mode, and baud rate.
Parameters for configuring the Proportional-Integral-Derivative control loop.
Lists common fault codes, their causes, and possible solutions for the inverter.
Provides guidance on diagnosing and resolving motor-related malfunctions.
Information on electromagnetic compatibility and potential radio interference.
Parameters related to start/stop commands, direction setting, and frequency sources.
Configuration of digital and analog I/O terminals for various functions.
Parameters for timing control and system protection features.
Crucial parameters for motor identification, tuning, and performance optimization.
