P350 Operation Manual
The flexitrax Power Supply Unit has a number of ventilation slots around the casing that are designed to maximize air
circulation and reduce heat. There is a potential fire risk if the build-up of heat is prevented from escaping. Under no
circumstances are these ventilation slots to be covered or blocked.
If using a generator follow the manufacturer’s instructions on load connection and sequencing. In the absence
of these instructions the following guidelines should be used:
1. When starting the generator; ensure that all electrical loads, including the P350 are switched off before starting
the generator. Allow the generator to stabilize before connecting any electrical loads or switching on the P350.
2. When stopping the generator; ensure all electrical loads, including the P350 are switched off before stopping
the generator.
3. Starting or stopping a generator whilst the P350 system is connected and the main switch is in the On position
could lead to damage to the P350 system or the generator.
Always use heavy-duty industrial gloves when handling cable which is being withdrawn from a sewer.
Always ensure that cabling is properly connected.
A portable generator can be a hazard if not properly operated. Always follow the manufacturer’s instructions.
Always transport a generator with the minimum amount of fuel in the tank.
Always switch the system on and off using the main system switch.
Never lower crawlers or other heavy equipment into manholes while personnel work in the manhole.
To avoid risk of burns do not touch cameras or lightheads when they are switched on or immediately after switch off.
Leave ample time for them to cool before handling.
The camera’s LEDs are very powerful. Do not look directly at the LEDs or point them at other people.
Caution must be taken when conducting any pipeline or draining system inspection. Please observe all safety
warnings located in the Preface and throughout this operation manual.
Before you attempt to operate the P350 flexitrax system, it is recommended that you familiarize yourself with any
additional health and safety requirements that may be defined by company policy and any applicable local or national laws.
Contact your company’s or local government’s health and safety officer for further information. Any depth estimation
information resolved using the Sonde features should be considered a guide only, we cannot be held liable for inaccurate
locate data.
Where the cable moves and exits the drums there exists a crush hazard. Do not insert your body parts, allow loose
clothing or permit any items into these areas.
The following safety precautions apply to the P350+ controller only, which contains a Li-Ion rechargeable battery:
CAUTION: Only use charging equipment provided by Pearpoint Ltd. The use of alterative chargers may cause
a safety/fire hazard and / or reduce the life of the battery.
CAUTION: Do not tamper with, or attempt to disassemble the battery.
CAUTION: If battery failure is suspected, it may be necessary to return the entire unit to an authorized repair
center for investigation and repair. Local, national or IATA transport regulations may restrict the shipment of faulty
To Next Page
Loading...