Operation guidelines
Please observe your company, region or country’s Standard Code of Practice for surveying underground utilities with
CCTV equipment, if applicable, when using this equipment.
Safety precautions
Always carry out a risk assessment of the site to be inspected. This equipment is NOT approved for use in areas
where hazardous gasses, liquid or solids may be present.
Foul water systems can be a source of serious biological hazards. Wear appropriate protection when handling the
P350 flexitrax.
The camera will get hot during use. This is normal. Exercise care when handling the camera at all times.
System components must NOT be connected/ disconnected or connectors touched while the power is on. Ensure all
connections are connected before switching on the system. Do not touch the connectors while powered on.
There are no user-serviceable internal components. The system (in particular the PSU) should not be opened by
ANYONE except approved service houses with authorised training from Pearpoint on specific tasks, as these have high
voltage components that could remain hazardous with the mains supply disconnected.
Never place hands, clothes or foreign objects into the mechanism of the powered elevator.
The external connectors of the P350 Manual PSU unit and Powered Drum are required to be properly sealed
by the blanking caps provided or by using the correct leads to prevent water damage to the units. Under no
circumstances are these connectors to be left un-blanked. The controller I/O panel has a rainproof socket flap covering
the I/O socket – this must be closed at all times wet conditions are expected. In particular, large USB drives or cables
may prevent this panel from closing – ensure this is closed during wet operation. The power must be switched off
while the tractor/camera/lighthead/elevators are removed from the system. The system cannot be “hot plugged” which
may cause damage to the system components.
CAUTION: On all downhole equipment, a modified screw is used to
ensure waterproof connections to the C-Clamp securing connector. It is critically
important that only screws supplied by Pearpoint are used, to ensure waterproof
and reliable connection. Significant damage and costs will occur if "off-the-shelf"
screws are used – which will not be covered by our warranty.
CAUTION: Take care to ensure that video and power cables do not get
entangled in the drum. Cable ties are recommended and will not impede system
performance. Always store the P350 flexitrax system in a clean and dry
environment.
Ensure that standard safety precautions for working in hostile environments are followed.
The flexitrax Power Supply Unit (PSU) is designed to reduce hazards from electric shock provided that proper
operating procedures are followed. The P350 flexitrax system requires connection to a protective earth; if in doubt, consult a
qualified electrician.
Electrical equipment is factory tested for electrical safety. Routine inspection is recommended (and may be required
to maintain this level of protection). If you are unsure, contact your local safety authority for advice.
To Next Page
Loading...