Installer Manual Fleck 5800 - XTR - Maintenance
Ref. MKT-IM-006 / B - 16.01.2018 103 / 122
9.2.8. Replacing the optical sensor
No. Operation
A Remove the controller, see 9.2.2. Replacing the controller, page 96.
B Disconnect the wire from the motor to the optical sensor (4).
C Release the optical sensor support (1) by pushing it back and up as shown.
D Release the optical sensor (3) from its support (1) by pressing the clips (2).
E Change the optical sensor (3).
F Reverse above procedure steps to rebuild.
To Next Page
Loading...
