Installer Manual Fleck 5800 - XTR - Operation
94 / 122 Ref. MKT-IM-006 / B - 16.01.2018
8.6. Remote lockout
If a remote switch is installed, the controller will not allow the system to go into regeneration until the
regeneration lockout input signal to the controller is cleared. This requires opening the contact
closure to clear the lockout condition. The recommended gauge wire is 20 with a maximum length of
500 feet. See 5.8. Electrical connections, page 45.
8.7. Sleep mode
The controller will go into sleep mode if no button is pressed after five minutes. All other controller
functions will continue to operate. The display will wake from sleep mode when any part of the display
is touched.
To Next Page
Loading...
