Installer Manual Fleck 5800 - XTR - Programming
Ref. MKT-IM-006 / B - 16.01.2018 61 / 122
6.3. Master setting programming
Note
If a regeneration is scheduled to occur while in master settings, the scheduled regeneration
will start as soon as exiting the master setting.
Note
Due to the complexity of these settings and the potential for errors, master settings should
only be accessed by your local water professional.
Caution
Improperly adjusting master settings may cause the system to operate incorrectly. Before
entering master settings please contact your professional water dealer.
The following is a detailed overview of settings available in Master Settings. Please see 6.4. Master
setting reference chart, page 61 for the complete set of values and ranges available to program while
in master settings.
6.4. Master setting reference chart
Note
Some items may not be shown depending on controller configuration.
Note
The controller will discard any changes and exit master settings if any button is not pressed
for five minutes.
To Next Page
Loading...
