Pentair Fleck 5800 XTR - Operation; Display During Operation; Display During Regeneration; Controller Operation During Programming

Installer Manual Fleck 5800 - XTR - Operation
92 / 122 Ref. MKT-IM-006 / B - 16.01.2018
8. Operation
8.1. Display during operation
8.2. Display during regeneration
During regeneration, the regeneration cycle wheel shows the regeneration step the valve is advancing
to, or has reached (green), and the time remaining in that step (1). Once all regeneration steps are
complete the valve returns to treatment position and resumes normal operation. The time remaining
in regeneration will be displayed on the home screen in hours and minutes.
Pressing the button during a regeneration cycle immediately advances the valve to the next cycle
step position and resumes normal step timing. The button is only shown when the valve is in
position and the motor has stopped.
8.3. Controller operation during programming
The controller can only be programmed with the valve in treatment. While being programmed the
controller continues to operate normally, monitoring water usage and keeping all displays up to date.
Controller programming is stored in memory permanently until reset.
Water treatment
wed
12:01 am
4.5
m
3
d
treatment
tank refill
rapid rinse
backwash
draw
Regeneration
48 m
34 s
treatment
tank refill
rapid rinse
backwash
draw