Pentair Fleck 5800 XTR - Replacing the Controller Motor

Installer Manual Fleck 5800 - XTR - Maintenance
Ref. MKT-IM-006 / B - 16.01.2018 97 / 122
9.2.3. Replacing the controller motor
No. Operation
A Remove the controller, see 9.2.2. Replacing the controller, page 96.
B Disconnect the optical sensor (3).
C Disconnect the motor.
D Open the motor clips (1) and pull out the old motor (2).
E Change the motor (2).
F Reverse above procedure steps to rebuild.