Installer Manual Fleck 5800 - XTR - Programming
58 / 122 Ref. MKT-IM-006 / B - 16.01.2018
Note
If immediate volumetric regeneration has been set, regeneration time will have no influence
on it and regeneration will start as soon as capacity end.
Note
Changing the hardness setting recalculates treatment volume and regeneration interval.
This setting should only be changed on the advice of a professional.
Note
The hardness parameter is not accessible in timeclock and filter mode.
Press to save your changes or press to return to the home screen without saving.
Note
Additional features may be accessed from the Settings screen by pressing the buttons at the
bottom of the screen:
6.2.8. Master setting screens
The master settings screens include all configurable parameters available in the controller.
From the settings screen, press the settings button . A warning message appears:
Press to continue to the password screen or press to return to the home screen.
Master settings:
Displays the master settings screen, which allows you to fully
program the valve.
Brightness:
Displays the brightness screen, which allows you to adjust the
backlight brightness of the controller screen.
Master Settings
before entering
master programming
please contact your local
water professional
To Next Page
Loading...
