Installer Manual Fleck 5800 - XTR - Programming
50 / 122 Ref. MKT-IM-006 / B - 16.01.2018
6. Programming
6.1. Home screen
Note
If no button is pushed for five minutes, the screen will enter a power save mode. The unit
will continue to operate, but the screen will be blank. Touch anywhere on the screen to exit
power save mode.
Note
Not all buttons appear on all screens.
1. Regeneration → Displays the regeneration screen, which allows you to start
a regeneration and manually cycle through the regeneration
steps.
2. Settings → Displays the settings screen, which allows you to adjust
commonly used settings. Pressing this button while in the
settings screen provides access to the master settings
screen, which allows you to fully program the valve.
3. Diagnostics → Displays the diagnostics screen, which can assist in
performing maintenance and troubleshooting performance
issues with the valve.
4. Assistance → Displays a name and phone number to call for unit service.
Water Treatment
wed
12:01 am
4.5
m
3
treatment
backwash
draw
tank refill
rapid rinse
To Next Page
Loading...
