Pentair Fleck 5800 XTR - Settings Review; Remote Regeneration Screen

Installer Manual Fleck 5800 - XTR - Programming
84 / 122 Ref. MKT-IM-006 / B - 16.01.2018
6.4.7. Settings review
From the master settings screen press the settings review button to display the settings review
screen, which display a read-only summary of all programmed settings in the controller.
Use the navigation arrows at the top of the screen to scroll through the parameters currently set in
the controller. The settings review screens are formatted similarly to the corresponding screen
where each parameter was set.
Press to return to master settings.
6.4.8. Remote Regeneration screen
From the secondary master settings screen press the remote regen button to display the remote
regeneration screen.
remote signal duration: Contains settings for triggering a regeneration via a remote input. Set a
timing in seconds for contact closure in order to trigger the regeneration.
Format
units
hardness units
english
metric
mg/L
language
Remote Regeneration
remote signal
duration
off