Installer Manual Fleck 5800 - XTR - Programming
Ref. MKT-IM-006 / B - 16.01.2018 75 / 122
regen flow: Contains settings for the type of regenerant flow to be used in the valve. Changes to this
setting affects the cycle steps displayed in the regeneration cycle wheel on the home screen.
Regenerant flow cycle steps are described below. See 6.1. Home screen, page 50 for cycle step
definitions.
upflow: Cycle steps are as follows: draw, backwash, rapid rinse, tank refill.
downflow: Cycle steps are as follows: backwash, draw, rapid rinse, tank refill.
downflow 2x backwash: Cycle steps are as follows: backwash, draw, backwash, rapid rinse, tank
refill.
filter: Cycle steps are as follows: backwash, rapid rinse.
Note
This option appears only if regeneration type is set to time clock or filter metered delayed
or immediate.
custom upflow/downflow/filter: Allows for up to 20 programmable cycle steps.
Note
Custom filter appears only if regeneration type is set to time clock or filter metered delayed
or immediate.
variable refill/brining: Cycle steps are as follows: tank refill, pause, draw, backwash, rapid rinse.
Variable refill / brining calculates refill time based on salt dosage, media volume, and BLFC size.
Note
This option appears only if regeneration is set to metered delayed.
Note
If regeneration type is set to filter meter delayed or immediate, the only options for
regeneration flow are filter and custom filter.
Press to save and pass to the next screen or press to return to the master settings screen
without saving.
To Next Page
Loading...
