18 / 84
industrial heat tracing solutions
EN-RaychemNGC30UIT2Programming-AR-H5818602/16
• Press Enter.
Step 4E: Press on the Mode field and a pop-up window appears, showing all available
control modes
Fig. 2.11 Mode window pop-up
Step 4E (continued): Pop-up window for control mode appears
Fig. 2.12 Mode - Select window
At the Mode - SELECT window:
• This pop-up window lets you select a Circuit’s basic operating mode. The NGC-30-CRMS, used
in this example, has the following Control modes available: On/Off, Always On, Always Off,
PASC, Voltage and Proportional.
• The On/Off mode is a simple setpoint/dead band operation.
• Press On/Off to select this control mode and return to the Setup Circuit window.
To Next Page
Loading...
