45
Shooting Functions
4
Pictures can be taken consecutively while the shutter release button is
held down.
1
Press the drive mode button [g]
until [j] appears on the LCD
panel.
2
Press the shutter release button halfway down to focus on
the subject.
3
Press the shutter release button completely.
Pictures are taken consecutively while the shutter release button is fully
pressed. Take your finger off of the shutter release button to stop taking
consecutive pictures.
Consecutive Shooting
• When the focus mode lever is set to l (single), the focus is locked in the
first frame position and used for subsequent continuous frames.
• When the focus mode lever is set to k (continuous), the focus is adjusted
for each shot. However, note that the shutter will release even if the focusing
is not complete.
• The shutter cannot be released until charging is complete when using the
built-in flash. Use a custom function to enable shutter release before the built-
in flash is ready. See page 115 for setting Custom Functions.
To Next Page
Loading...
Need help?
General
