41
⑦ CCD number input screen is displayed.
⑧ Select Input or Skip and execute the program.
<Not replace T100 or C000>
Click [Skip]
<Replaced T100 or C000>
Input I-CCD number twice.
Click [IMPUT]
* If cancel the adjustment, click [CANCEL]
⑨ Adjusting screen (It takes about 3.5 minute)
[Caution]
Do not give vibration to the camera while adjusting, also do not even walk around the camera also.
If you give vibration to the camera while adjusting, repeat the adjustment even pass the adjustment.
*If you want to stop the adjustment, click [Stop].
⑩
When the following screen is displayed, adjustment is completed.
⑪ Confirm that “Unconnect” is displayed then click [x] to finish the adjustment.
*If adjustment is NG, green part will be changed to red.
⑫ Unsolder main SW land on T200.
Main SW
Land
To Next Page
Loading...
