126
Shooting Functions
4
5
Press the four-way controller (3)
and use the four-way controller
(45) to select h, i, or i.
The self-timer lamp will blink to let you
know that the camera is in remote control
wait status.
6
Press the 4 button.
The camera is ready to take a picture.
7
Press the shutter release button halfway.
The autofocus system operates. The focus indicator ] appears in the
viewfinder when focused.
8
Point the remote control unit
towards the remote control receiver
on the front or back of the camera
and press the shutter release button
on the remote control.
The operating distance of the remote
control unit is about 5 m from the front or
back of the camera.
For h, the shutter will be released
immediately after the shutter release
button is pressed.
For i, the shutter will be released in
three seconds after the shutter release
button is pressed.
After the picture is taken, the self-timer lamp lights for 2 seconds and
then returns to blinking.
For i, continuous shooting starts immediately after the shutter release
button is pressed. To exit continuous shooting, press the shutter release
button on the remote control unit again.
You cannot focus with the remote control unit in default settings. Focus on the
subject first before operating with the remote control. You can set [AF in remote
control] to [On] in the [A Custom Setting] menu. (p.74)
OK
To Next Page
Loading...
Need help?
General
