Pentax K20D User Manual

127
Shooting Functions
4
• Exposure may be affected if light enters the viewfinder. Attach the provided
ME viewfinder cap or use the AE lock function (p.102). (To ignore the light
entering the viewfinder, set the exposure mode to a (Hyper-manual) (p.93).)
• Select a setting other than h, i or i in the Drive Mode options screen to
stop the remote control operation after it has been activated. The setting is
canceled when the camera is turned off if [Drive Mode] in [Memory] of [A
Rec. Mode] menu (p.236) is set to P (Off).
• The remote control may not operate in backlit conditions.
• The remote control does not work while the flash is being charged.
•
When using the built-in flash, raise the flash into position first.
• The remote control unit battery can send a remote control signal about
30,000 times. Contact PENTAX Service Center to replace the battery (this
will involve a fee).
• The Shake Reduction function is automatically turned off when h, i or i
is set.
Removing the Eyecup FP Attaching the ME Viewfinder cap

Pentax K20D Specifications

General

Camera Type	Digital SLR
Sensor Type	CMOS
Sensor Size	23.4 x 15.6 mm
Resolution	14.6 MP
Continuous Shooting Speed	3 fps
Image Stabilization	Sensor-shift
Screen Size	2.7 inches
Screen Resolution	230, 000 dots
Storage Media	SD/SDHC
Dimensions	141.5 x 101 x 70 mm
Weather Sealing	Yes
Image Processor	PRIME (Pentax Real Image Engine)
Shutter Speed	30-1/4000 sec
Viewfinder	Optical (pentaprism)
Battery	Rechargeable Lithium-Ion battery
ISO Range	ISO 100 - 3200 (expandable to 6400)