LIBRARIES
PerkinElmer Life and Analytical Sciences 111
A:UL - Upper Limit Region A
This field represents the upper counting limit for region A, measured in keV.
A:Half Life - Half Life of Nuclide A
This field represents the half-life of nuclide A.
A:Units - Units for Region A
This field represents the units for the half-life of nuclide A.
B:LL - Lower Limit Region B
This field represents the lower counting limit for region B, measured in keV.
B:UL - Upper Limit Region B
This field represents the upper counting limit for region B, measured in keV.
B:Half Life - Half Life of Nuclide B
This field represents the half-life of nuclide B.
B:Units - Units for Region B
This field represents the units for the half-life of nuclide B.
C:LL - Lower Limit Region C
This field represents the lower counting limit for region C, measured in keV.
C:UL - Upper Limit Region C
This field represents the upper counting limit for region C, measured in keV.
C:Half Life - Half Life of Nuclide C
This field represents the half-life of nuclide C.
C:Units - Units for Region C
This field represents the units for the half-life of nuclide C.
Quench Set:Low, Mid, High - Quench Sets
Select a quench set by clicking one or more of the quench set buttons. Select the
Quench Set Low set if you are counting one nuclide in one counting region, the
Quench Set Medium if you are counting two nuclides in two counting regions and
the Quench Set High if you are counting three nuclides in three counting regions.
The Quench Standards Library window is displayed. Select the name of the
quench standards you would like to use for calculating DPM values. The names of
the quench sets selected should appear on the Quench Set buttons. Note:
Depending on the DPM options installed, you may not have access to all three
quench sets.
To Next Page
Loading...
