32 . Spectrum Two N User's Guide
Installing your Spectrum Two N
NOTE: Do not connect your instrument to the PC using the USB cable provided until you
have run the software installation wizard.
NOTE: If you wish to connect to your instrument using an Ethernet cable, you will need to
configure the PC network adaptor. We recommend that you do this before installing
your software.
To install your software package (Spectrum, Spectrum ES, or AssureID, as required),
insert the supplied DVD or USB Flash Drive and follow the instructions on the screen.
You will need to select Spectrum Two as the Installation Type in Spectrum and
Spectrum ES software.
If required, full installation instructions are provided in the Administrator’s Guide for
your software, which can be found on the
Spectrum Two Manuals CD
supplied with your
instrument.
If you are supplying your own computer, make sure that it meets the minimum
requirements for hardware and software set out in the “PC Requirements” section of the
Administrator’s Guide.
Spectrum and Spectrum ES software applications are available in German, English, Spanish,
French, Japanese, Brazilian Portuguese and Simplified Chinese. The software language
displayed is determined by the Region and Language settings defined for the operating
system on the PC.
During the Spectrum software installation you will be provided with USB and wireless
connection instructions (Figure 11). Connect your instrument to the mains power, and then
set up your USB or wireless connection. For other connection methods, you do not need to
connect up your instrument at this point. Refer to
Connecting the spectrometer to the PC
using the USB cable
on page 34 or
Connecting the spectrometer to the PC using the wireless
router
on page 36, as applicable.
Figure 11 USB and Wireless Connection Instructions dialog
To Next Page
Loading...
Need help?
General
