(Table 240, contd)
Service Error Identifiers
Description Troubleshooting
$10CB
Engine Load Too High
Delivered fuel volume must be less than the
limit shown during the service tool test. An en-
gine speed from the application is preventing
the service test from taking control of the de-
sired engine speed. Check that the machine
is in a suitable operating mode before running
the service test.
$1162
Fuel Leakage Detected
Follow the troubleshooting procedure for the
fuel leakage event.
$1101 Fuel Rail Pressure Too Low
Refer to Troubleshooting, “Fuel Rail Pressure
Problem”.
$1100
Fuel Rail Pressure Too High
The pressure relief valve may have opened
due to high rail pressure and is now regulating
the rail pressure to be less than 80 MPa
(11600 psi). The rail pressure may be control-
ling incorrectly to be too high. Refer to Trou-
bleshooting, “Fuel Rail Pressure Problem”.
$1118
Fuel Pressure Not Responding
Indicates that the rail pressure control is un-
stable during the service test. Contact the
Dealer Solutions Network (DSN) if this fault
occurs repeatedly when running the service
test.
Fuel Rail Pressure Test
$0002
Active Diagnostic Present
Resolve any active diagnostic codes. Refer to
the appropriate troubleshooting procedure.
Check that there are no electrical diagnostics
on the fuel system-related sensors or actua-
tors and no injector faults relating to injector
trim codes.
$1161
Fuel Temperature Too High
Fuel temperature must be above the threshold
shown in service tool and no high fuel temper-
ature events are active.
$10FB
Engine Speed Too Low
Engine speed must be higher than or equal to
low idle speed.
$10FC
Engine Speed Too High
Engine speed must be lower than or equal to
rated speed.
$10CB
Engine Load Too High
Delivered fuel volume must be less than the
limit shown during the service tool test. An en-
gine speed from the application is preventing
the service test from taking control of the de-
sired engine speed. Check that the machine
is in a suitable operating mode before running
the service test.
$1162
Fuel Leakage Detected
Follow the troubleshooting procedure for the
fuel leakage event.
$1101 Fuel Rail Pressure Too Low
Refer to Troubleshooting, “Fuel Rail Pressure
Problem”.
(continued)
488 UENR4469-36
Service
Copyright of Perkins Engine Company Limited. NOT FOR REPRINTING OR RESALE
To Next Page
Loading...
