EasyManua.ls Logo

Perkins 1206E-E66TA - Fire Extinguisher; Lines, Tubes and Hoses

Perkins 1206E-E66TA
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SEBU8603-01 13
Safety Section
Fire Prevention and Explosion Prevention
g00704059
Illustration 12
Use caution when you are refueling an engine. Do
not smoke while you are refueling an engine. Do not
refuel an engine near open ames or sparks. Always
stop the engine before refueling.
g00704135
Illustration 13
Gases from a battery can explode. Keep any open
ames or sparks away from the top of a battery. Do
not smoke in battery charging areas.
Never check the battery charge by placing a metal
object across the terminal posts. Use a voltmeter or
ahydrometer.
Incorrect jump
er cable connections can cause
an explosion that can result in injury. Refer to
the Operation Section of this manual for specic
instructions
.
Do not charge a frozen battery. This may cause an
explosion.
The batteries must be kept clean. The covers
(if equippe
d) must be kept on the cells. Use the
recommended cables, connections, and battery box
covers when the engine is operated.
Fire Extinguisher
Make sure that a re extinguisher is available. Be
familiar with the operation of the re extinguisher.
Inspect th
e re extinguisher and service the re
extinguisher regularly. Obey the recommendations
on the instruction plate.
Lines, Tubes and Hoses
Donotbendhighpressurelines.Donotstrikehigh
pressure lines. Do not install any lines that are
damaged
.
Leaks can cause res. Consult your Perkins dealer
or your P
erkins distributor for replacement parts.
Replace the parts if any of the following conditions
are pre
sent:
High pressure fuel line or lines are removed.
End ttings are damaged or leaking.
Outer
coverings are chafed or cut.
Wires are exposed.
Outer coverings are ballooning.
Flex
ible part of the hoses are kinked.
Outer covers have embedded armoring.
End ttings are displaced.
Mak
e sure that all clamps, guards, and heat shields
are installed correctly. During engine operation, this
will help to prevent vibration, rubbing against other
par
ts, and excessive heat.

Table of Contents

Related product manuals