SEBU8603-01 95
Maintenance Section
Engine Mounts - Inspect
Check the System
g02346500
Illustration 58
Typical e xample
Inspect the breather tube (1) for damage. Ensure that
the outlet (2) is clean and free from any obstructions.
Ice can cause obstructions in adverse weather
conditions.
i02323089
Engine Mounts - Inspect
Note: The engine mounts may not have been
supplied by Perkins. Refer to the OEM information
for further information on the engine mounts and the
correct bolt torque.
Inspect the engine mounts for deterioration and for
correct bolt torque. Engine vibration can be caused
by the following conditions:
•
Incorrect mounting of the engine
•
Deterioration of the engine mounts
•
Loose engine mounts
Any engine mount that shows deterioration should
be replaced. Refer to the OEM information for the
recommended torques.
i03996001
Engine Oil Leve l - C heck
Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot com ponents to
contact the
skin.
g02173847
Illustr
ation 5 9
“L” Low
“H” High
NOTICE
Perform this maintenance with the engine stopped.
Note: Ensure that the engine is either level or that
the engine is in the normal operating position in order
to obtain a true level indication.
Note: After the engine has been switched OFF, wait
for 10 minutes in order to allow the engine oil to drain
to the oil pan before checking the oil level.
1. Maintain the oil level between the mark (L) and
the mark (H) on the engine oil dipstick. Do not fill
the crankcase above the “H”.
NOTICE
Operating your engine when the oil level is above the
“FULL” mark could cause your crankshaft to dip into
the oil. The air bubbles created from the crankshaft
dipping into the oil reduces the oil's lubricating char-
acteristics and could result in the loss of power.
2. Remove the oil filler cap and add oil, if necessary.
C
lean the oil filler cap. Install the oil filler cap.
If an increase in the oil level is noticed, refer to
Troubleshooting, “Oil Contains Fuel”.
To Next Page
Loading...
