Preparation
9 - 8
9.09.02 Applying fullness constantly
● Turn adjustment wheel 1 to “+“ as far as it will go.
● Turn adjustment wheel 2 until the desired level of fullness (green numbers) is at
marking 3.
● Turn adjustment wheel 1 back until the same green number is at marking 3.
● Adjust the stitch length (see chapter 9.08 Adjusting the stitch length).
The sum of the selected fullness level and the stitch length must not exceed
4.5 because more than this lessens the stitch length.
Fig. 9 - 13
Fig. 9 - 12
1
0
2
3
4
1
2
3
To Next Page
Loading...
