Preparation
9 - 9
9.09.03 Applying fullness intermittently
● Turn adjustment wheel 1 to “+“ as far as it will go.
● Turn adjustment wheel 2 until “0“ is at marking 3.
● Turn adjustment wheel 1 back until the desired level of fullness (green numbers) is
at marking 3.
● Adjust the stitch length (see chapter 9.08 Adjusting the stitch length).
The sum of the selected fullness level and the stitch length must not exceed
4.5 because more than this lessens the stitch length.
When the left pedal is in resting position the machine sews with equal
bottom and top feed strokes. By activating the left pedal the level of fullness
set on adjustment wheel 1 is sewn into the top fabric layer
(see chapter 7.03 Pedal).
Fig. 9 - 14 Fig. 9 - 15
1
0
2
3
4
1
2
3
To Next Page
Loading...
