Use of network services
53
Conference Call
(Subscription dependent)
The user can activate the conference call by making consecutive outgoing calls, or create it
from a multiparty call context. The user may have up to five members at the same time. He can
end the conference with . At this point all calls are disconnected.
When making consecutive outgoing calls, first initiate a normal call with the first number of the
conference. Then when the first member is on line, initiate a second call as described in making
a second call paragraph page 51.
When the second call is engaged, press the Pilot Key and select
.
Repeat the above
process up to five members.
If there is an incoming call during the conference call, and if there is less than the five members,
you can, by pressing the Pilot Key, accept the second call as described in paragraph "answering
a second call" page 51, or, by pressing the Pilot Key and then selecting , you can add
this member to the conference call.
If there is an incoming call during a conference with five members already connected, you can
answer this new incoming call, but not add it to the conference.
Explicit Call Transfer
(Subscription
dependent)
You can connect an active call and a call on hold. You are disconnected when the transfer is
complete. During a call press the Pilot Key , select
Transfer
and confirm by pressing
the Pilot Key .
In-call symbols
During calls, you have the following symbols:
Mute
Call underway
Active call placed on
hold
Incoming call
Outgoing call
Conference
Conference
To Next Page
Loading...
Need help?
General
