Technical data
108997_en_04 PHOENIX CONTACT 85 / 226
Connection data
Connection method Push-in spring connection
Note on the connection method Use only copper connecting cables providing the permitted
temperature range (-40°C ... 75°C).
pluggable Yes
Conductor cross section solid min. 0.25 mm²
Conductor cross section solid max. 1.5 mm²
Conductor cross section flexible min. 0.25 mm²
Conductor cross section flexible max. 1.5 mm²
Conductor cross section AWG min. 24
Conductor cross section AWG max. 16
Stripping length 9 mm
Interface: Ethernet (RJ45)
Number of interfaces 6
Connection method RJ45
Note on the connection method Auto negotiation and autocrossing
Transmission physics Copper
Transmission speed 10/100 Mbps
Transmission length 100 m (per segment)
Interface: Ethernet FO
Number of interfaces 2
Connection method SC
Transmission physics multi-mode fiberglass
Transmission speed 100 Mbps (full duplex)
Transmission length 11000 m (fiberglass with F-G 62.5/125 0.7 dB/km F1000)
Transmission length 6400 m (fiberglass with F-G 50/125 0.7 dB/km F1200)
Transmission length 3000 m (fiberglass with F-G 62.5/125 2.6 dB/km F600)
Transmission length 2800 m (fiberglass with F-G 50/125 1.6 dB/km F800)
Wavelength 1300 nm
Supply voltage
Supply voltage 24 VDC (redundant)
Residual ripple 3.6 V
PP
(within the permitted voltage range)
Supply voltage range 9 VDC ... 57 VDC
Typical current consumption 255 mA (at U
S
= 24VDC and 25°C ambient temperature)
Max. current consumption 1.5 A (U
S
= Min, T
amb
= Max, DO
I
= Max)
Maximum power dissipation for nominal condition 6.75 W (U
S
= Min, T
amb
= Max, DO
I
= Max)
Test section for one minute 500 VDC
To Next Page
Loading...
Need help?
General
