Piazzetta MP 973 - Cleaning the Fans; When Not in Use; Scheduled Maintenance

DT2010095-06
7.10 CLEANING ThE FANS
DT2010096-04
7.11 whEN NOT IN USE
a Any cleaning or maintenance work must be carried out after the CURRENT HAS BEEN SWITCHED OFF.
The stove is tted with fans (smoke extractor and heating) positioned at the bottom rear of the stove.
Any build-up of dust or ash on the blades can unbalance them resulting in noise during operation.
It is necessary to have the fans cleaned annually. Since such an operation involves dismantling certain parts of the stove, have the cleaning carried
out only by a Piazzetta Service Centre or other qualied persons.
When shutting the stove down for the summer, proceed as follows:
- remove all pellets from the hopper and feeding auger;
- carefully clean the grate, the grate support and the ash drawer;
- using a steel brush, clean the bafe plate or internal bafe plates of the rebox and coat them using the spray paint, supplied with the kit, to prevent
them from oxidising and consequently forming rust.
a If the cast-iron parts inside the rebox are not coated, rust could form. This is a natural process, which does not affect the efciency
and quality of the product.
- Clean the ue thoroughly: contact a professional chimneysweep for this purpose;
- clean by removing all dust, cobwebs, etc. from the area behind the inner lining panels once a year, in particular the fans;
- disconnect the power cable from the power supply;
- remove the batteries from the remote control.
DT2012636-00
7.12 SChEdULEd MAINTENANCE
a Scheduled maintenance must be carried out ONCE A YEAR and prior to starting up the appliance, especially after a long period of
inactivity. This maintenance is necessary to ensure the appliance remains in efcient and safe working order.
a The appliance must be DISCONNECTED FROM THE POWER SUPPLY for all cleaning and maintenance work.
a Since the following maintenance necessitates removing some parts of the appliance, it is advisable to have the scheduled maintenance
carried out by an After-Sales Service Centre or a qualied person.
- Clean the grate (see “CLEANING THE GRATE”);
- Clean the rebox (see “CLEANING THE FIREBOX”);
- Clean the ue system (see “CLEANING THE FLUE SYSTEM”);
- Clean the painted metal parts (see “CLEANING THE ENAMELLED METAL PARTS”);
- Clean the glass (see “CLEANING THE GLASS”);
- Clean the fans (see “CLEANING THE FANS”);
- Clean away dust and cobwebs from the gap between the appliance and the cladding;
- Check the electrical part and the electronic components;
- Check the tightness and state of the gaskets/seals of the glass door and of all the elements subject to wear and if necessary replace;
- Carry out all maintenance and checks required for correct operation and compliance with safety regulations and standards;
- Light the appliance in accordance with instructions given under “LIGHTING FOR THE FIRST TIME”.
H072047UK0 / DT2001513 – 04
59
English