Piazzetta MP 973 - Troubleshooting Common Issues; Emptying the Brazier After Shutdown; No Lit Start-up Failure (E9)

EMPTY BRAZIER
Description Display message
If the stove was - either voluntarily or due to power failure - shut down during the START PHASE I
or START PHASE II, the brazier must be cleaned of unburnt pellets after the smoke motor has been
switched on.
Next, press the ON/OFF key
EMPTY
BRAZIER
BRAZIER
EMPTIED
1 2:0022
.
c
1
BRAZIER
EMPTIED
NO 22
.
c
1
YES 22
.
c
1
10:30 OFF
1
Select YES with the selection key.
• Conrm that the brazier has been cleaned with the SET key.
If any problems arise during this phase regarding operation or remote control reception thus making
it impossible to send commands to the stove, turn the stove off by pressing and holding the ON/OFF
key on the emergency display for 15 seconds (until the led lights stop ashing).
EMPTY
BRAZIER
BRAZIER
EMPTIED
1 2:0022
.
c
1
BRAZIER
EMPTIED
NO 22
.
c
1
YES 22
.
c
1
10:30 OFF
1
EMPTY
BRAZIER
BRAZIER
EMPTIED
1 2:0022
.
c
1
BRAZIER
EMPTIED
NO 22
.
c
1
YES 22
.
c
1
10:30 OFF
1
The appliance shuts off.
To re-start the stove (see the “STOVE START-UP” table)
EMPTY
BRAZIER
BRAZIER
EMPTIED
1 2:0022
.
c
1
BRAZIER
EMPTIED
NO 22
.
c
1
YES 22
.
c
1
10:30 OFF
1
DT2012309-00
6.5 POSSIbLE PRObLEMS ANd SOLUTIONS
Below are a list of situations which could arise with possible solutions.
Description Display message
The stove is in the start-up phase, the message “NO LIT E9” appears and the alarm beep sounds.
The stove does not ignite since the smoke temperature probe has not detected an increase in
temperature (indicating that the combustion process has not started) or there is no fuel being supplied.
When the stove is new or has shut down due to the pellets being fully depleted even if the hopper is
full, it is possible that in the ignition phase the pellets are not distributed in the combustion chamber
until the auger has been completely loaded.
E7
1 2:0022
.
c
1
!
NO LIT
E9
1 2:0022
.
c
1
!
NO LIT
H072047UK0 / DT2001513 – 04
32
English