7. The wet / dry tape lever is an optional feature for SendPro MailCenter 3000 devices. Use this
lever to set the type of tape you are using on your system. The wet / dry tape lever is located to
the right of the printer module, behind the stacker.
Push the lever to the right for dry tapes or pressure-sensitive tapes.
Push the lever to the left for wetting gummed tapes.
8. The stacker is where mail is deposited after the postage is applied to the piece of mail. It is
located on the right side of the system. The drop stacker shown here is available with every
device. An optional power stacker is also available.
9. The printheads produce the printed postage.
10. Ink is deposited in the waste ink tray during the printhead cleaning process. The device will alert
you when the waste tray is nearing full capacity.
11. The moistener pad assembly moistens the flaps on the envelope. The moistener pad assembly
is located beneath the moistener deck on SendPro MailCenter devices. To access it, lift the top
release lever and then use the blue notch to pull on and open the moistener deck.
Getting Started
Pitney Bowes User Guide April 2024 11
To Next Page
Loading...
