Changing the sealing method
You can change the sealing method for a job while running mail. You can turn the sealer on and off or
seal envelopes without printing postage.
1. Ensure that the appropriate job is open and selected on the Run Mail screen.
2. Select the Sealer icon.
3. Select the appropriate sealing option.
l
Select Sealing on to print postal and / or non-postal elements and seal the envelope.
l
Select Sealing off to print postal and / or non-postal elements without sealing the envelope.
l
Select Sealing only, No printing to seal the envelope without printing.
4. If you select Sealer on or Sealing only, No printing you can adjust the wetness of the sealer for
this job. Select and drag the control button to adjust the wetness. 1 is the driest setting; 9 is the
wettest. Use the + and - buttons for a more precise selection. This adjustment only changes the
wetness setting for the selected job. If you do not adjust the wetness, the job will use the default
sealer wetness setting.
5. If you are using a SendPro MailCenter 3000, and you selected Sealing on or Sealing only, No
printing, select the appropriate flap position:
l
All envelopes are open flap and nested, or
l
Some envelopes are closed flap (No previously sealed envelopes).
6. Select OK.
7. Select Start to run the job, or Reload job to return to the previously saved version of the job.
Setting or changing Seal Only mode
Use Seal Only mode to seal envelopes without printing anything on the envelope.
Set Seal Only mode
Use Seal Only mode to seal envelopes without printing anything on the envelope.
1. Select Run Mail from the Home screen.
2. Select Sealer.
3. Select Sealing only, No printing.
4. Select OK.
Sealing
Pitney Bowes User Guide April 2024 83
To Next Page
Loading...
