Reloading the default job
There is always at least one job open in Run Mail - the default job.
The default job is special:
l
it is always open, and
l
it is protected so you don't overwrite it easily.
To clear all changes made while running mail and to return to the default job to its original state, select
the Reload job link on the default job tab.
Closing all jobs
Select Start over on the Run Mail screen to close all open jobs, discard all unsaved edits made to
saved jobs, discard all unsaved jobs and reload the default job.
Important: The Start over option does not allow you to save changes made to the default job.
Counting mail without printing postage
If your meter uses accounting, you can create a job to count mail without printing postage. The piece
count will be included in accounting reports.
If you have already created a count only job, open the job and begin running mail.
1. Select the Run Mail button in the Mailing tile on the Home screen.
2. Select the Options button.
3. Select Create new job....
4. Select Count Only.
5. Select OK. The job appears in a new job tab.
6. Select the appropriate counter and then select OK.
l
Total - Count only: total number of pieces for the current job.
l
Resettable - Count only: the total number of pieces run since you reset the counter.
7. Select an account.
8. If necessary, select a surcharge.
9. Select Start to begin feeding and counting envelopes.
Jobs
Pitney Bowes User Guide April 2024 61
To Next Page
Loading...
