Powering On/Off Planar UltraRes Displays
Planar UltraRes User Manual 17
Planar UltraRes in Standby Mode
If you are unsure about whether or not the display is on but in standby mode, look for
the small Standby LED. If it is off, you will not see the LED. If it is on but in Standby
mode, you will see a blue LED. As the display starts, the LED blinks until the display is
seen. Once it is there, the LED turns off.
Insert IR sensor cord into the IR
input located on the I/O panel
this side.
To Next Page
