VIP User’s Manual
Command Line Interface
95
Console session
a) Connect VIP through the 9-pin RS232 female console (No password required)
Under ITG> prompt, insert command: download to enter VIP firmware upgrade mode.
b) Insert command: “start” and answer questions on screen to proceed firmware upgrade.
c) When VIP prompts downloading firmware file into EEPROM, insert “y” to continue.
d) Wait till firmware is fully loaded into VIP, insert “quit” to leave firmware upgrade mode and
answer “y“ to reboot machine when VIP prompts for restart.
ITG>download
============================== WARNING ==============================
* Entering download mode will hang up all telephone connections *
* and all the configuration settings will lose. *
* Be certain all the configuration settings have been saved. *
=======================================================================
Do you want to enter download mode now (y/n)? [n] y
Boot loader V4.12
Loading TFTP loader.....................
** Internet Telephony Gateway TFTP Loader Ver 4.10 **
EITGLoader>start
IP address of the TFTP server? [192.168.0.254] 192.168.0.7
File name? it4p315.imz
Starting download file: it4p315.imz
.................................................................................................................................................................
..........................................
Download complete, file size = 833004
Application code downloaded successfully
Do you want to write downloaded image to flash EEPROM (y/n)? [y] y
Press <Enter> to start flash EEPROM programming
Flash EPROM programming on-going, BE CERTAIN NOT TO TURN POWER OFF...
Flash sector no. 4 write done
Flash sector no. 5 write done
Flash sector no. 6 write done
Flash sector no. 7 write done
Flash sector no. 8 write done
Flash sector no. 9 write done
Flash sector no. 10 write done
Flash sector no. 11 write done
Flash sector no. 12 write done
Flash sector no. 13 write done
Flash sector no. 14 write done
Flash sector no. 15 write done
Flash sector no. 16 write done
Flash EEPROM programming completed
All sectors programmed successfully
Download another file (y/n)? [n] n
EITGLoader>quit
Do you want to restart the system now (y/n)? [n] y
To Next Page
Loading...
Need help?
General
