VIP User’s Manual
Command Line Interface
58
The new IP address will not take effect until VIP is reset.
net set ip_preced ip_preced
VIP allows you to set the 8-bit Service Type field in the IP header for all the voice packets it sends
out. The Service Type field is broken down into five subfields, among which four subfileds are user
configurable. This command is used to set these subfields.
net set ip_preced ip_preced [d] [t] [r]
Syntax description
ip_preced
The 3-bit PRECEDENCE subfiled ranging from 0 through 7.
d
The D bit subfield, either 0 or 1.
t
The T bit subfield, either 0 or 1.
r
The R bit subfield, either 0 or 1.
Default
ip_preced: 0
d: 0
t: 0
r: 0
Notes
The new setting will not take effect until the VIP is reset.
net set mask ip_mask
Use the net set mask command to set the IP subnet mask for VIP.
Syntax description
ip_mask
The subnet mask of your network.
Note
The new setting will not take effect until VIP is reset.
net set speed {10|100|auto}
VIP allows you set the link speed for its Ethernet interface. Use the net set speed command to set
the Ethernet link speed.
Syntax description
10
Fixed the Ethernet speed at 10 Mbps
100
Fixed the Ethernet speed at 100 Mbps
To Next Page
Loading...
Need help?
General
