VIP User’s Manual
Configuring VIP from a Web Browser
35
VIP will generate ring back tone before receiving Alerting message from remote gateway. (CLI only)
11. Cisco T.38:
This option is used for FAX transmitting while VIP interoperating with Cisco 5300. (CLI only)
4.3.2.2 H323 Gatekeeper Settings
Please select Main Menu\Configure System Settings\H.323 Parameter Settings\H.323 Gate-
Keeper Settings
Gate Keeper Mode: The default setting is off. This field is to select the co-operation mode with some
gatekeeper(s). Three options available:
off: disables gatekeeper co-operation,
auto: enables auto-discovery of the gatekeeper
manual: enables gatekeeper co-operation in manual operation (the gatekeeper address must be
properly assigned).
The following fields must be filled up when the Gate Keeper Mode is set to either auto
or manual.
Gate Keeper Address: Specify the gatekeeper address when configured to manual mode. When auto
mode is desired, this field should be set to auto.
Allow Calls Without Gate Keeper: This field is to inform the H.323 stack to allow calls when the end-
point is not registered with a gatekeeper.
Registration Type: This field is to set the endpoint registration type. This specifies how the endpoint
will register itself with the gatekeeper.
Max Registration Retries: This field is to control how many registration attempts will be made before
the endpoint considers itself to have failed registration.
You'll have to reboot the system to make your changes active!
To Next Page
Loading...
Need help?
General
