VIP User’s Manual
Command Line Interface
98
set mask ip_mask
Use the set mask command to set the IP subnet mask for VIP.
Syntax description
ip_mask
The subnet mask of your network.
Note
The new setting will not take effect until VIP is reset.
start
Use the start command to start downloading code from TFTP server. VIP will prompt you for the IP
address of the TFTP server and the file to download.
8.3 Restore default configuration
If there is system re-organization, firmware upgrade or improper parameters are loaded in VIP-
000/200/400/400FS/400FO, restoring factory default settings may help you to restore initial state of
machine and restart configuration.
Following are steps loading VIP series default parameters:
Note: restore process in this session only can be applied to firmware version 3.xx)
System configuration default parameters
a) Logon VIP via telnet or console connection, and insert command: config erase
b) After this command, VIP pops up a warning message and prompts for confirmation.
c) Press ”y” to erase current system configuration parameters,
d) Enter net reset to reboot and load the default system parameters into machine.
e) Log on VIP, and insert command: config store to load factory default parameters into VIP.
To Next Page
Loading...
Need help?
General
