VIP User’s Manual
Command Line Interface
85
set port port em guard_all milliseconds
Syntax description
milliseconds
Time in milliseconds, ranging from 0 to 65535.
Default
400
set port port em guard_out
This command is used to set an additional period of time after guard_all when incoming calls will be
accepted but outgoing calls will not be initiated for aborted call.
set port port em guard_all milliseconds
Syntax description
milliseconds
Time in milliseconds, ranging from 0 to 65535.
Default
400
set port port em offhook_db
This command is used to set the off-hook debounce interval, in milliseconds.
set port port em offhook_db milliseconds
Syntax description
milliseconds
Time in milliseconds, ranging from 0 to 65535.
Default
50
set port port em onhook_db
This command is used to set the on-hook debounce interval, in milliseconds.
set port port em onhook_db milliseconds
Syntax description
To Next Page
Loading...
Need help?
General
