User Manual of WNAP-7320
-7-
IEEE 802.11n: 24 ± 1dBm
Receiver Sensitivity
IEEE 802.11a: -92 ~ -73dBm @ 6Mbps ~ 54Mbps
IEEE 802.11n: -94 ~ -73dBm @ MCS0 ~ MCS15
Output Power Control 3~27dBm
Software Features
Built-in DHCP server supporting static IP address distributing
LAN
Supports 802.1d STP (Spanning Tree)
WAN
Static IP
Dynamic IP
PPPoE
PPTP
L2TP
IPSec
Operating Mode
Bridge
Gateway
WISP
NAT firewall with SPI (Stateful Packet Inspection)
Built-in NAT server supporting Virtual Server and DMZ
Firewall
Built-in firewall with Port / IP address / MAC / URL filtering
Wireless Mode
AP
Client
WDS PTP
WDS PTMP
WDS Repeater (AP+WDS)
Channel Width 20MHz / 40MHz
Wireless Isolation
Enable it to isolate each connected wireless clients from communicating with
each other mutually.
Encryption Type 64/128-bits WEP, WPA, WPA-PSK, WPA2, WPA2-PSK, 802.1X
Provides wireless LAN ACL (Access Control List) filtering
Wireless MAC address filtering
Supports WPS (WIFI Protected Setup )
Wireless Security
Enable / Disable SSID Broadcast
Multiple SSID Up to 2
Max. Wireless Client 40
Max. WDS AP 8
Max. Wired Client 60
WMM Supports Wi-Fi Multimedia
QoS Supports Quality of Service for bandwidth control
NTP Network Time Management
Management Web UI, DHCP Client, Configuration Backup & Restore, Dynamic DNS, SNMP
Diagnostic tool System Log, Ping Watchdog
Mechanical & Power
IP Rate IP55
To Next Page
Loading...
Need help?
General
