Planet WNAP-7320 - Appendix B: Configuring the PC in Windows 7

User Manual of WNAP-7320
-90-
Appendix B: Configuring the PC in Windows 7
In this section, we’ll introduce how to configure the TCP/IP correctly in Windows 7. First make sure your Network
Adapter is working, refer to the adapter’s manual if needed.
1) On the Windows taskbar, click the Start button, and then click Control Panel.
2) Click the Network and Sharing Center icon, and then click the Change adapter settings on the left
side of the screen.
Figure B-1
3) Right click the icon of the network adapter shown in the figure below, and select Properties on the
prompt window.