• height (Z-axis) (3)
• width control measurement / only Pos 2 (4)
Take the following measurements with a precision of 10 μm and send the
results to your local dealer to be inserted into the offset calculation program.
15.3.3.4 Calculation and data transfer
• The offset values for the Planmeca PlanCAM software are determined
after the measurement results are entered into the calculation program.
• Please contact the local dealer of your Planmeca PlanCAM software to
implement the offset data.
15 Adapters
66 Planmeca PlanMill 60 S User's manual
To Next Page
Loading...
