EasyManua.ls Logo

Planmeca Proline EC pan - Page 97

Planmeca Proline EC pan
210 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter E - DIMAX3 DIGITAL SYSTEM ADJUSTMENT
Planmeca Proline EC X-ray unit E-3
REQUIRED TOOLS
Technical Manual
• Beam alignment tool (part number 50972). For checking the position of the panoramic X-
ray beam.
• Cephalostat calibration tool (part number 10002935). For calibrating the cephalostat.
• Panoramic mode calibration block (part number 665413). For calibrating the panoramic
sensor head.
Beam alignment too

Table of Contents

Related product manuals