Statement of reference loading conditions (leakage radiation)
The maximum rated peak tube potential is 120 kV and the maximum rated
continuous tube current is 2.1 mA for the maximum rated peak tube voltage.
1.9 EMC information
WARNING
Use of any accessories and cables other than those specified in the X-ray
unit’s documentation, with the exception of cables sold by Planmeca as
replacement parts for internal components, may result in increased emission
or decreased immunity of the X-ray unit.
WARNING
The X-ray unit should not be used adjacent to or stacked with other
equipment. If adjacent or stacked use is necessary, the X-ray unit should be
observed to verify its normal operation in the configuration in which it is
used.
Guidance and manufacturer’s declaration - electromagnetic emissions
The Planmeca Viso X-ray unit is intended for use in the electromagnetic environment specified
below. The customer or the user of the X-ray unit should assure that it is used in such an
environment.
Emissions test Compliance Electromagnetic environment –
guidance
RF emissions
CISPR 11
Group 1 The X-ray unit uses RF energy
only for its internal function.
Therefore, its RF emissions are
very low and are not likely to
cause any interference in
nearby electronic equipment.
1 General and technical data
Technical manual Planmeca Viso 27
To Next Page
