2 Settings
CAUTION
Some of the settings can be used to alter the operation of the X-ray unit.
Never use functions that you are not familiar with.
NOTE
The options shown on the touch screen depend on the unit configuration.
The views and values shown in this manual are only examples.
NOTE
The illustrations shown on the touch screen are based on approximate
patient anatomy. The actual exposure area depends on the individual
anatomy of the patient.
NOTE
Never allow patients to touch the screen when they are positioned in the X-
ray unit. Touching the screen during exposure will stop the imaging process.
The unit has a number of additional functions for special requirements. The
function modes that can be entered without a password are User settings
and About general information of the X-ray unit.
Technical settings are for the use of service personnel only and are
protected with a password.
In this manual, only some of the settings are described, all other menus are
described in the X-ray unit’s user’s manual.
The settings are entered as follows: Touch the setting symbol on the main
display.
You can return to the Main display by touching the setting symbol at the top
left corner.
2.1 Technical settings
To enter the technical settings, select the Technical tab. The technical
setting mode is password protected and the password prompt displays when
the mode is selected for the first time after switching the unit on.
The password is 1701.
2.1.1 Calibrations
Select Calibrations. The unit calibrations are performed in this mode.
NOTE
Detailed descriptions of calibrations are given in respective sections later in
this manual.
2 Settings
32 Planmeca Viso Technical manual
To Next Page
