PMC PH-2 - Iso Lubrication System

POLYURETHANE
MACHINERY
CORPORATION
PH-2 SERVICE MANUAL
13. MAINTENANCE
5. Reinstall the Screen, Spring and Seal. Screw on the Strainer Screw and screw in Plug.
6. OPEN the Poly (R) Proportioner Inlet Valve, pressurize the Material Transfer Pump,
check for leaks and wipe Y-strainer clean.
7. Repeat above for the Iso (A) side.
8. Proceed with Proportioner Purging operation (See page 23).
13.2 ISO LUBRICATION SYSTEM
DAILY: Check the condition of the PMC Lube Oil in the Iso Lube Reservoir.
Replace the PMC Lube Oil if you see significant changes in the color or signs of
solidification. Ensure inside of Reservoir is wiped clean.
To replace the Lube Oil, proceed as follows:
1. Remove the Lube Reservoir from its support, unscrew the Lid and remove the Check
Valve from the Suction Hose.
2. Empty the contaminated Lube Oil in a waste container and refit the Check Valve in
the Suction Hose.
NOTE! Valve is directional.
3. Clean the Reservoir, refill with Lube Oil, and screw on the Lid and place the Reservoir
in its support.
The system is auto-suction and does not need priming.
REVISION 1.2 48