Poly Polycom RealPresence Group Series User Manual

Switch Between Point-to-Point Calls
When you have a call on hold, you can switch between the held and active calls.
Procedure
1. Press Home.
2. Select Manage > Switch To.
Resume a Call
When you no longer want to keep a call on hold, you can resume the held call.
Procedure
» Use your remote control to select Resume Call.
End a Call
When your call is complete, hang up the call.
Procedure
» On the remote control, press .
Conference Calls
Conference, or multipoint, calls involve at least three different endpoints or sites. All endpoints or sites
can participate in conference calls when using a bridge, such as the RealPresence
®
Collaboration Server
800s, to host the conference call. The number of sites allowed in the call is determined by the capabilities
of the bridge hosting the call. Check with your system administrator to find out how many sites are
allowed in a bridged conference call.
Place a Conference Call
To start a new conference call, you need to start with the first participant or site and then add additional
participants and sites.
Procedure
1. Call the first site.
2. After the call connects, press on the remote control to open the dialing keypad.
3. Place a call to the next site.
4. Repeat the above steps until all sites are connected.
Calling
16

Poly Polycom RealPresence Group Series Specifications

General

Brand	Poly
Model	Polycom RealPresence Group Series
Category	Conference System
Language	English