Integrators’ Reference Manual for ViewStation EX, ViewStation FX, and VS4000
54 www.polycom.com
Keep in mind that the examples given here discuss only a single
point-to-point call. Your capacity planning calculations must take
into account the total number of calls that you expect the network to
handle at one time, including multipoint calls. In addition, you will
need to factor in the requirements for any other traffic that the
network must handle.
For detailed information about capacity planning, please refer to the
Polycom white paper, H.323 Bandwidth Considerations, available
at www.polycom.com.
Call Processing Considerations
After documenting your network topology, you will need to define:
❑ Call processing architecture
❑ Gatekeeper identifier
❑ Default gatekeeper
❑ Call routing mode
Defining the call processing architecture is outside the scope of this
document. Please refer to the PathNavigator Deployment Guide in
the Documentation section at www.polycom.com for detailed
information on this topic.
1.5 Mbps 1 PRI line 1.843 Mbps
2.0 Mbps Multiple
a
PRI lines or E1 line
(Europe)
2.4 Mbps
a. Requires a third-party inverse multiplexer. Inverse multiplexers
provide inverse multiplexing to transmit a single high-speed data
channel over one or many T1 (PRI) or E1 links.
Table 3-2. Bandwidth Requirements
To Next Page
Loading...
Need help?
General
