Command Protocol Reference Guide
A - 49
phone_exit_tone_en
Enable Exit Tones For Telephony Interface
Description
This parameter enables or disables exit tone generation for the telephony inter-
face. If exit tones are enabled (1), then an exit tone is played whenever the
auto-hangup feature engages and disconnects the telephony interface. Entry
tones (see the phone_entry_tone_en parameter) and exit tones are typically
enabled to prevent a caller from entering or exiting a conference unannounced.
phone_flash
Connect Or Disconnect Telephony Interface
Description
Setting this parameter disconnects the telephony interface then reconnects it
after a short delay. The amount of delay can be configured with the
phone_flash_delay parameter.
Examples
Argument Argument value
Channel Type Virtual Channel
Value Type Boolean
Read/Write Mode Read/Write
Phys Chans Analog Telephony Input, VoIP Telephony Input
Virt Chans Mono
Default 1
Event Source No
Argument Argument value
Channel Type Virtual Channel
Value Type Void
Read/Write Mode Write-Only
Phys Chans Analog Telephony Output
Virt Chans Mono
Event Source No
Command Response Description
To Next Page
Loading...
Need help?
General
